The ones left using av_gettime are NTP timestamps (for RTCP,
which is specified to send the actual current realtime clock
in RTCP SR packets), and the NUT muxer timestamper, which is
documented as using wallclock time.
Signed-off-by: Martin Storsjö <martin@martin.st>
This allows both the main playlist itself as well as the variant
playlists to handle redirects combined with relative URLs.
Signed-off-by: Martin Storsjö <martin@martin.st>
This allows the chained demuxer (or more precisely, the lavf
utility code) to better fill in timestamps on packets from
these, especially for cases where one stream is a raw ADTS
stream.
Signed-off-by: Martin Storsjö <martin@martin.st>
Also parse segment durations as floating point, which is allowed
since HLS version 3.
This is based on a patch by Zhang Rui.
Signed-off-by: Martin Storsjö <martin@martin.st>
When first_timestamp was stored as-is, its actual time base
wasn't known later in the seek function.
Additionally, the logic (from 795d9594cf) for scaling it
based on stream_index is flawed - stream_index in the seek
function only specifies which stream the seek timestamp refers
to, but obviously doesn't say anything about which stream
first_timestamp belongs to.
In the cases where stream_index was >= 0 and all streams had the
same time base, this didn't matter in practice.
Seeking taking first_timestamp into account is problematic
when one variant is mpegts (with real timestamps) and one variant
is raw ADTS (with timestamps only being accumulated packet
duration), where the variants start at totally different timestamps.
Signed-off-by: Martin Storsjö <martin@martin.st>
Without the information, an application may choose audio from one
variant and video from another variant, which leads to fetching two
variants from the network. This enables av_find_best_stream() to find
matching audio and video streams, so that only one variant is fetched.
Signed-off-by: Martin Storsjö <martin@martin.st>
Also adjust the streams timestamps according to their start
timestamp when comparing. This helps getting correctly interleaved
packets if one stream lacks timestamps (such as a plain ADTS
stream when the other variants are full mpegts) when the others
have timestamps that don't start from zero.
This probably doesn't work properly if such a stream is
temporarily disabled (via the discard flags) and then reenabled,
and such streams are hard to correctly sync against the other
streams as well - but this works better than before at least.
The segment number restriction makes sure all variants advance
roughly at the same pace as well.
Signed-off-by: Martin Storsjö <martin@martin.st>
If passing the end of one segment while initializing the
chained demuxer, the parent demuxer's streams aren't set up
yet, so we can't recheck the discard flags.
Signed-off-by: Martin Storsjö <martin@martin.st>
This serves as a safeguard; normally we want to use the dts
comparison to interleave packets from all active variants. If that
dts comparison for some reason doesn't work as intended, make sure
that all packets in all variants for a certain sequence number have
been returned before moving on to the next one.
Signed-off-by: Martin Storsjö <martin@martin.st>
Previously, we returned any error code except AVERROR_EOF to the
caller - only if AVERROR_EOF or 0 was returned, we proceeded to
the next segment.
With some setups of web servers, using Connection: close in https
and GnuTLS, we don't get a clean error code at the end of segments.
In those cases, just proceed to the next segment.
Tested-by: Antti Seppälä <a.seppala@gmail.com>
Signed-off-by: Martin Storsjö <martin@martin.st>
This avoids reading any old data in the AVIOContext buffer after
the seek, and indicates to the mpegts demuxer that we've seeked,
avoiding continuity check errors.
Signed-off-by: Martin Storsjö <martin@martin.st>
Enhance seeking by demuxing until the requested timestamp is
reached within the segment selected by the seek code using the
playlist info.
Some mpegts streams don't have dts set for all packets though,
this seeking method doesn't work well for that case.
Signed-off-by: Martin Storsjö <martin@martin.st>
When this demuxer was created, there didn't seem to be any
consensus of a common short name for this protocol. Now
the consensus seems to be to call it hls.
Signed-off-by: Martin Storsjö <martin@martin.st>
According to draft-pantos-http-live-streaming-07, 6.3.4,
the duration of the last media segment in the playlist
should be used as initial minimum reload delay.
Signed-off-by: Martin Storsjö <martin@martin.st>
This avoids a segfault if the probe function wasn't able to
determine the format.
The bug was found by Panagiotis H.M. Issaris.
Signed-off-by: Martin Storsjö <martin@martin.st>
The Apple HTTP Live Streaming demuxer's implementation of
seeking searches for the MPEG TS segment which contains the
requested timestamp. In its current implementation it assumes
that the first segment will start from 0.
But, MPEG TS streams do not necessarily start with timestamp
(near) 0, causing seeking to fail for those streams.
This also occurs when using live streaming of HTTP Live Streams.
In this case sliding playlists may be used, which means that in
that case only the last x encoded segments are stored, the earlier
segments get deleted from disk and removed from the playlist.
Because of this, when starting playback of a stream in the middle
of such a broadcast, the initial segment fetched after parsing
the m3u8 playlist will not start from timestamp (near) 0, causing
(the admittedly limited live) seeking to fail.
This patch changes this demuxers seeking implementation to use
the initial DTS as an offset for searching the segments containing
the requested timestamp.
Signed-off-by: Martin Storsjö <martin@martin.st>
Manual replacements are done in this commit.
In many cases, the id is some constant made up number (e.g. 0 for video
and 1 for audio), which is then not used in the demuxer for anything.
Those ids are removed.
Adding _POSIX_C_SOURCE to CPPFLAGS globally produces all sorts of problems
since it causes certain system functions to be hidden on some (BSD) systems.
The solution is to only add the flag on systems that really require it, i.e.
glibc-based ones.
This change makes BSD systems compile out-of-the-box without the need for
adding specific flags manually. It also allows dropping a number of flags
set manually on a file-per-file basis, but were only present to work around
breakage introduced by the presence of _POSIX_C_SOURCE.
Also add _XOPEN_SOURCE to CPPFLAGS for glibc systems. We use XSI extensions
in several places already, so it is preferable to define it globally instead
of littering source files with individual #defines only needed for glibc.
If there are no variants, the total bitrate of the single
stream isn't known, and exporting variant_bitrate = 0 does
look weird, since there really aren't any variants.
Signed-off-by: Martin Storsjö <martin@martin.st>
This should hopefully fix roundup issue 2586.
This commit only implements it in the demuxer, not in the
protocol handler. If desired, some of the code could be
refactored to be shared by both implementations.
Signed-off-by: Martin Storsjö <martin@martin.st>
Make AVIO_FLAG_ access constants work as flags, and in particular fix
the behavior of functions (such as avio_check()) which expect them to
be flags rather than modes.
This breaks API.
This code could be executed if the demuxer reads more than one
segment before returning from av_open_input_stream.
Signed-off-by: Martin Storsjö <martin@martin.st>
Martin Storsjö
Michael Niedermayer
LYF
Reimar Döffinger
Diego Biurrun
Mans Rullgard
Panagiotis H.M. Issaris
Alex Converse
Anton Khirnov
Andrey Utkin
Luca Barbato
Stefano Sabatini